View Full Version : paste LTFT log file to VE table
rumblebox
April 8th, 2013, 02:26 PM
after months of battling with my LC-1 i finally ripped it out and said fuck it.
now i'm just doing as well as i can by tuning with fuel trims.
i can't figure out how to copy my LTFT log MAP onto my VE table as a percentage. i dont know how a red cell with 300 counts translates to correction on the VE table.
joecar
April 8th, 2013, 06:17 PM
Make a map of LTFTBEN x MAP x RPM (i.e. to match VE table; in map's row and col tabs do Paste Labels from VE table)...
then paste-with-multiply into the VE table.
If you're looking at cell counts, why don't you click the x-bar button (x with bar over it, i.e. average value of each cell)...?
Post screensots.
rumblebox
April 10th, 2013, 02:18 AM
Thanks. Found it. After 1 log/tune, it runs drastically better... as expected.
joecar
April 10th, 2013, 06:50 AM
ok, cool :cheers:
rumblebox
April 10th, 2013, 07:28 AM
For PE's I'll just use the wideband on the dyno..... Or just let patrick do it lol
joecar
April 12th, 2013, 12:03 PM
I thought you got your LC-1 serial comms going...?
If you're going to get tuned by Patrick, it might be easier to let him do it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.