LS1Inferno
April 16th, 2013, 06:30 PM
I am looking at picking up an l76 with 6l80, harness, computers, etc..
I have a 2002 trans am and i would like some answers.
First, what is the serial data protocol, is it compatible with the cluster and bcm in the F car. (If i even need that data for the cluster and BCM to work, specific information is hard to find)
If not is there any very detailed information on it since i can read it into an arduino or something and tell the f car whatever i want.
I would be a royal pain, but could be worth it and im a fairly decent programmer.
Next does it have to remain BDW or can i pin in a TPS and IAC and use my cable with my current cruise control/traction control motor.
ANY information would be helpful. I know i'm in for a lot of work, but i always like building things that look and work as if they were factory.
I have a 2002 trans am and i would like some answers.
First, what is the serial data protocol, is it compatible with the cluster and bcm in the F car. (If i even need that data for the cluster and BCM to work, specific information is hard to find)
If not is there any very detailed information on it since i can read it into an arduino or something and tell the f car whatever i want.
I would be a royal pain, but could be worth it and im a fairly decent programmer.
Next does it have to remain BDW or can i pin in a TPS and IAC and use my cable with my current cruise control/traction control motor.
ANY information would be helpful. I know i'm in for a lot of work, but i always like building things that look and work as if they were factory.