View Full Version : Quick wideband hookup question
ferocity02
May 18th, 2013, 07:39 AM
Quick question about hooking up a wideband to my V1 unit. It's an AEM wideband with a white wire for 0-5V analog output. This wire will go to either Pin C (EXT.AD2) or Pin E (EXT.AD1). But do I need to hook anything to Pin D the common ground? If I do need to, would I just hook it to the same ground that I'm using to feed the gauge?
Thanks
joecar
May 19th, 2013, 09:39 AM
Yes, ground, yes same is usually ok (if there is not a specific signal ground/return wire).
ferocity02
May 19th, 2013, 12:20 PM
Yes, ground, yes same is usually ok (if there is not a specific signal ground/return wire).
Thanks! I used the same ground that I used for the gauge, seems to be working well. The reason I was confused was that my Prosport wideband had a separate ground for data logging and the AEM doesn't.
Mikz86ta
May 21st, 2013, 03:04 PM
I just used the white to AD1 EXT. Works fine
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.