LC-1 viewing on V2. Wo2 not found

[dave361]

I can view AFR on laptop via Wo2-Analog but cant seem to get serial to work. wo2 not found. I got LC1 to serial to null modem to V2 and V2 to truck. no light flashing second from left on V2. please help

[joecar]

Did you insert the null terminator plug (looks like a blank 2.5mm stereo jack) into SERIAL IN on the LC-1...?

Did you configure V2 as follows:
- com port set to Wideband,
- wideband set to Innovate,

V2 can be configured either by the Options menu item on the LCD, or by running V8 S&T and going to Devices.

[dave361]

it works perfect now all I needed was the right stuff.

[MarkR8]

Hope someone can help me. Here's what happened (try not to laugh).
Took off on a logging run and all was working prior to departure but shorty realised I had no WBO2 working.
After checking connections everywhere I found myself looking to see if the null connector was plugged in and that was when I knew I had dramas.
The A/D cable from the Innovate interface had dropped through the splash guard and wrapped itself around the front wheel hub. This happened while everything was connected!

After repairing the A/D cable I still have no WBO2 found on my V2 and I have checked it with a known good (brand new LC-1).
Settings are good on V2 and this WB was working prior to the "incident".
I fear the serial input of my V2 is cactus and am concerned about reapair or replacement as I have many licenses on this device that I still need.

Any help would be appreciated

[dave361]

is there a fuse in you LC1 circuit?

[MarkR8]

The LC-1 is running as it should but I am not able to receive data through the Serial port on my V2.
I suspect this problem is now with FS because I connected another LC-1 to it and still couldn't find a WBO2

[joecar]

The LC-1 is running as it should but I am not able to receive data through the Serial port on my V2.
I suspect this problem is now with FS because I connected another LC-1 to it and still couldn't find a WBO2So it was previously working and now it doesn't...?


Sanity checks:
- LC-1 SERIAL IN has terminator plug...?
- null modem adapter...?
- V2 Device configured for Wideband and Innovate...?
- V2 connected to vehicle ALDL port...?

[MarkR8]

So it was previously working and now it doesn't...?


Sanity checks:
- LC-1 SERIAL IN has terminator plug...?
- null modem adapter...?
- V2 Device configured for Wideband and Innovate...?
- V2 connected to vehicle ALDL port...?


Have checked all above with the exception, V2 not connected to vehicle. Was just powered up with USB.
I will set it all back up in the car again tomorrow and report back.
I no longer have a long Serial IN as it was damaged. To ensure continuity, I cut it back and terminated as per null terminator plug fitted (checked twice with a meter).

[joecar]

Ok.