dusto82
August 22nd, 2013, 01:09 AM
Hello,
Looking for some guidance as far as tuning on the dyno,
I will be getting my car on a dyno soon to have a better go at tuning my VVE table on my ls3 Maloo, I've been finding it hard to get enough steady state load data on the street.
i assume i will get the operator to set the dyno into steady state mode and hold rpm at set speed and use throttle to hit all the cells min 50 times
if i do this and hit all the cells will the map be right after a couple of time of applying BEN's
if i can get it within 2% would this be acceptable or should i be able to get bens of 1 every time? i assume the inovate wo2 would have a tolerance to error
after that is tuned i guess its a matter of finding mixtures for best power and set the timing for MBT by finding max torque
Looking for some guidance as far as tuning on the dyno,
I will be getting my car on a dyno soon to have a better go at tuning my VVE table on my ls3 Maloo, I've been finding it hard to get enough steady state load data on the street.
i assume i will get the operator to set the dyno into steady state mode and hold rpm at set speed and use throttle to hit all the cells min 50 times
if i do this and hit all the cells will the map be right after a couple of time of applying BEN's
if i can get it within 2% would this be acceptable or should i be able to get bens of 1 every time? i assume the inovate wo2 would have a tolerance to error
after that is tuned i guess its a matter of finding mixtures for best power and set the timing for MBT by finding max torque