pormgb
September 7th, 2013, 07:18 AM
Just completed modding my LS6 to pass CA smog, I added 243 heads, CAT's and the rest of the smog stuff.
I have used a base LS6 tune and want to use CALV.VET to correct my MAF and VE table, I have gone through the CALV.VET tutorial and made the necessary changes to my current tune.
After a run today, CALC.VET produced some numbers that created a very high area in my VE table, there are also quite a few spikes that can be due to not running the motor enough at those values.
Does this map look OK?
I have also posted the results on my VE table, CALC.VET produces a pretty good MAF table.
- 2002 LS6 with 226/229 575/585 116 LSA CAM
- 85MM MAF
- Innovate LM1 Wideband
- SVO 30lb Injectors (IFR Calculated)
I have done CALC.VET before and it worked well, I am just looking figure out if I am still doing something wrong.
157741578015776157811577915778
I have used a base LS6 tune and want to use CALV.VET to correct my MAF and VE table, I have gone through the CALV.VET tutorial and made the necessary changes to my current tune.
After a run today, CALC.VET produced some numbers that created a very high area in my VE table, there are also quite a few spikes that can be due to not running the motor enough at those values.
Does this map look OK?
I have also posted the results on my VE table, CALC.VET produces a pretty good MAF table.
- 2002 LS6 with 226/229 575/585 116 LSA CAM
- 85MM MAF
- Innovate LM1 Wideband
- SVO 30lb Injectors (IFR Calculated)
I have done CALC.VET before and it worked well, I am just looking figure out if I am still doing something wrong.
157741578015776157811577915778