Calculated pids not displayed on V2

[ttls1]

Hi, I have a custom list of pids i like to display on my V2. I have added some calculated ones like "engine oil pressure" and a "fuel rail pressure" pid i configured using the EGR input. They work in the scan software but not on my V2. I programmed them to the unit but they just dont show up in the list. Is there any tricks or something I may have missed? Cheers

[darcy]

No tricks - V2 simply can't display calc pids.

[joecar]

+1 calc pids do not display on V2... you have to view them in the V7 scantool.


When you program calc pids into your V2, a BBL log will note the fact that you want these calc pids selected when the log is opened in the V7 scantool (otherwise you have to manually select them (and save them into the log) after the fact (when viewing the log)).

[ttls1]

Ok, that explains it then. Thanks for the replys. It would be great if there was an updated firmware released that allowed the calc pids to be displayed on the V2