V2 acting up

[easymon]

Had a problem today went to plug v2 in and all it wanted to do is rapidly flash orange . Unplugged and re plug no go so thought try to load tune bad mistake. Then it Hung ecm pump kicking in and out . Well all I could think of is unhook battery ecm still hung so went and tryed to load tune and then it took.

[joecar]

If it flashes the two orange (amber) LEDs in alternation, then it is waiting for the firmware to be flashed in.

[joecar]

Did you get it sorted out...?

[easymon]

Ya got it working. Just wondering if the socal. Pass through cable caused the prob.. what I did is had csp5 in then later loaded straight file when I went back to load csp5 back in v2 checked for pids then only 2nd from last Orange was flashing fast . That's all it wanted to do

[easymon]

Was thinking when it auto check for pids when there is a straight file in it got confused? That do it mean when 1 orange light flashes. Thanks

[joecar]

When only one orange LED flashes --> V2 is communicating with ECM.

[easymon]

We found the problem it was the Socal csp5 pass through switch . Seems every now and again it frezzes or blocks traffic on network. Unplug and replug solves it .