PDA

View Full Version : LS1 with race pack IQ3 dash



LS1RX7
February 6th, 2014, 01:11 AM
Hi, I am brand new to EFI tunning, I am currently building an RX7 with an LS1 out of a 2002 Holden Commodore. It is purely a race car running standalone harness and no BCM. I intend to run a race pack IQ3 logger dash with the interface connected through the obd2 port. I am trying to decide which tunning software to go with. Has anyone here done anything similar using EFI Live? One reason I like EFI Live is I am told I could run a valet tune to use as a pit lane speed limiter. Is this possible and can you switch to the valet tune by holding down a momentary switch or flicking a toggle switch? Appreciate any help or advice.

Tre-Cool
February 6th, 2014, 02:37 AM
cant help u with the iq3 side of things, but the valet mod activates exactly how you describe it once setup.

i.e pin to ground.

LS1RX7
February 6th, 2014, 09:55 AM
Thanks for the reply, good to know that side will work for a pit lane speedlimlter. Can't do that with HP Tuners so EFI Live is looking more attractive from that side. My next question is how user friendly is EFI Live for someone that wants to learn to do their own tuning.
cant help u with the iq3 side of things, but the valet mod activates exactly how you describe it once setup.

i.e pin to ground.

joecar
February 6th, 2014, 10:15 AM
Depends...

there is a lot of reading:
- Calc-VET-correcting-MAF-and-calculating-VE-(in-single-log) (http://forum.efilive.com/showthread.php?15236-Calc-VET-correcting-MAF-and-calculating-VE-(in-single-log))
- Calc-MAFT-correcting-VE-and-calculating-MAF-(in-single-log)-gt-reverse-of-Calc-VET (http://forum.efilive.com/showthread.php?16413-Calc-MAFT-correcting-VE-and-calculating-MAF-(in-single-log)-gt-reverse-of-Calc-VET)
- Summary-Notes (http://forum.efilive.com/showthread.php?14188-Summary-Notes)
- Collecting-links-to-scattered-material (http://forum.efilive.com/showthread.php?2990-Collecting-links-to-scattered-material)
-Idle-Tips-amp-Tricks (http://forum.efilive.com/showthread.php?14439-Idle-Tips-amp-Tricks)

Especially read these:
- scantool user manual pdf
- tunetool user manual pdf

Download and install the V7 scantool/tunetool software from here, and play with it: Update-Nov-21-2013 (http://forum.efilive.com/showthread.php?23483-Update-Nov-21-2013)
Download and install the V8 software (new scantool, and V2 black box logging/flashing configuration software) that same thread.
You can find GM factory stock petrol calibration files here: www.tunefiledepot.com (http://www.tunefiledepot.com)

Authur Honegge
February 7th, 2014, 07:59 PM
Street Rod has provision for signal lights & speedometer - Comes with Oil pressure, and water temp sensors and all wiring you need. Does not include the speedo sensor.