Dashboard help

[tradin1]

I can not figure out how to build usable gauges. I am trying to datalog data on an A40 Allison 6spd. Does anyone have a dashboard with the following gauges from the TCM:

TPS%
Gear
VSS
TCC Lockup
TFT

I don't care what they look like as long as I can data log the info to help fine tune my shift points.

Thx

[joecar]

On the Dash A tab, do rightclick and choose a theme and choose a gauge...

then on the gauge do rightclick and choose a pid...

then on the gauge do richtclick->Properties and edit the high/low marks and the various properties to taste, click save, end exit.

[tradin1]

i will give that a try tonight. will it be that easy to build a gauge to tell me what gear the trans is actually in as it shifts?

[tradin1]

got everything to work except a tps signal from the tcm. do you know what pid to add for this signal in an A40 tcm?

thx

[joecar]

The only pid that comes close to being TCM throttle position is "Throttle Angle at Shift" GM.TPSSHFT, and I don't know if it is supported by A40.

[tradin1]

ok, ill check to see if that is the one that i used or not.

thx