E40 manual transmission gear ratio table?

[04colyZQ8]

I am trying to make a auto file into a manual file. I have located the trans type, lockout solenoid, in raw hex and corrected them. I also changed it to auto trans fitted, and corrected the reluctor tables, speedo tables, and BTM gear ratio tables. Cruise only works in gears 1-5, 6 doesn't work. Using scanner PID trans current gear it reads incorrect gear ratios. says I'm in second when I'm in first, 6th, when I'm in 5th??

If I change the rear gear ratio to a higher value, then cruise works in 6th, but gear ratios are still off, and speedo is then off. So I need to change the gear ratios.

There isn't a T42 in place, so its clearly using gear ratios stored in the PCM? Anyone know were? Even if its in raw hex, just tell me the constant for it, I can update the checksum, and work in raw hex.

[Highlander]

what transmission do you have?

[04colyZQ8]

T56, no trans Tcm just a PCM, the tables in the engine section. Somewhere?

[Highlander]

There are 2 T56 for the E40.. post your file..

[Highlander]

Send me your file in bin file if you have it.
desaintpreux at gmail dot com

[04colyZQ8]

17422

Change extension to bin in order to open. and I haven't changed B0501 yet! trans gear tables but it makes no difference. Note do not flash this file you will corrupt the PCM!!! Just for comparison

[Highlander]

Sorry... I can't help you.. this is not like the 0411 as I thought...

[Highlander]

And.. why not start from a manual file??? i would think its the best option.

[04colyZQ8]

I can't it has other attrabutes I'm after, that no other manual trans file has.

It registers 2-6 grears there just off, it's like the output shaft rpm, table needs to be adjusted if there is such a thing?

[Highlander]

what other attributes do you want from it?

[Highlander]

Change B0501 and see how it goes... because those are exactly for the Auto Transmission.... if its an "auto" file, it might still use those... if you see you still have 2.92 gear ratio on them.