View Full Version : Air/Fuel vs. Timing on stock ls1 with boost
ddnspider
September 25th, 2014, 09:46 AM
How do you guys normally setup a boosted stock longblock ls1's? I currently have the car setup for ~11.2:1 A/F on 93 octane with 12 degree's of timing. I also have the IAT timing table pulling 1 degree with IAT's starting at 100*F and then 2* over 130*. It looks like the A/F is right on except the top of 4th it dips down to ~10.8. Just trying to setup the car for longevity. It runs awesome and pulls hard, no knock either. I'm just looking to make it last.
TuneMaster
October 13th, 2014, 10:41 AM
Little bit fat for my liking, I normally aim for around 11.8:1 at the engine pipe and even this can be a tad bit rich but very safe. If its stock and depending on boost you can run 14-15 deg timing. Ive had 10psi boost on higher timing with 98 octane here in AUS.
ddnspider
October 13th, 2014, 11:21 AM
How long did the engine last like that? Everyone I've seen said they set it 11.2-11.5 and keep the timing safe.
joecar
October 13th, 2014, 12:31 PM
11.8 is only marginally past 11.5 so it is fine (if the IFR/VE/MAF are correct (or correctly scaled))...
he's done many of them.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.