PDA

View Full Version : lost my license


garyk1970
October 7th, 2014, 01:36 AM
hello,
i have flashed a cos3 and calibration in my ls1b ecm....ive got frustrated and decided to load a calibration and start over with the tune.....the programmer says i need another license? help...
garyk1970
October 7th, 2014, 01:49 AM
17581
joecar
October 7th, 2014, 12:25 PM
On the same PCM...?

What V7 and V8 software build versions are you running...?

Post a screenshot of what licenses your V2 knows about...
cindy@efilive
October 7th, 2014, 01:01 PM
Make sure you are using the latest EFILive software, available here:
https://forum.efilive.com/showthread.php?24704-Update-Oct-5-2014

Then if the problem still occurs, please locate the appropriate trace files as per the instructions here:
http://support.efilive.com/kb_articl...8254-QOGC-9586 (http://support.efilive.com/kb_article.php?ref=8254-QOGC-9586)

and email them to [email protected]

Cheers
Cindy
garyk1970
October 7th, 2014, 02:15 PM
Thanks.... I had all the latest updates....I'll figure out the other instructions. Thanks.
cindy@efilive
October 7th, 2014, 03:49 PM
Are you certain you are running October 5 software and not the July 19 public release software?

From the error code list:

$0534 Invalid Serial Number.

An attempt was made to program and license a controller that had a corrupt serial number.

It is possible for the serial number to appear corrupt due to a data transfer failure. Retry the operation a few times, if the error continues to occur then the serial number probably is corrupt. In that case, use the EFILive Tuning Tool software to full-flash the controller to restore the serial number.

Cheers
Cindy
garyk1970
October 8th, 2014, 02:33 AM
i bought another license, set everything up on a new laptop....cleared out the os and calibration, now i got this....

thanks everyone...
garyk1970
October 8th, 2014, 02:35 AM
yes same pcm....cannot acces the computer i was using then today. all updates were done...
garyk1970
October 8th, 2014, 02:36 AM
Are you certain you are running October 5 software and not the July 19 public release software?

From the error code list:

$0534 Invalid Serial Number.

An attempt was made to program and license a controller that had a corrupt serial number.

It is possible for the serial number to appear corrupt due to a data transfer failure. Retry the operation a few times, if the error continues to occur then the serial number probably is corrupt. In that case, use the EFILive Tuning Tool software to full-flash the controller to restore the serial number.

Cheers
Cindy

thanks, please see post above.