PDA

View Full Version : Blingy New Manifold



TAQuickness
April 27th, 2006, 10:02 AM
Check these out:
http://www.professional-products.com/manifoldsLS1LS2.php

I think I'm going to try one out when they are released (late May early June according to PP).

Tydriver
April 27th, 2006, 11:11 AM
LMFAO... A manifold just for my swap !!! Thats awesome..

Trippin
April 28th, 2006, 05:09 AM
Aluminum?

Why would anyone replace their plastic manifold with aluminum?

Unless of course the end goal is to increase the heat of the intake charge. :nixweiss:

TAQuickness
April 28th, 2006, 05:14 AM
I would do it to avoid being at the mercy of FAST. If i were looking for every 0.00000001 hp I could find, I might reconsider.

Imagine a manifold within +-2 HP of the Fast90 that cost half the price.

joecar
April 28th, 2006, 07:48 AM
It's made of metal, not plastic, I like metal, cool. :cheers:

Forcefedperformance
April 29th, 2006, 02:28 PM
We Have Done A couple of the aluminum intakes on the ls1/ls6 and never could get them to seal right. Spent most of the time chasing intake leaks.



Bill
www.forcefedperformance.com

TAQuickness
April 29th, 2006, 09:22 PM
I can barely get my fast90 to seal up....

ringram
April 30th, 2006, 04:22 AM
Where did you hear/see the performance specs and prices of these?

Any data yet?

Bruce Melton
May 1st, 2006, 03:09 AM
Previous AL manifolds (Weiand and BBK) were badly hampered by heat soak. And yes, the FAST is expensive, leaks and eats MAPs in Y bodies.

TAQuickness
May 1st, 2006, 03:36 AM
Where did you hear/see the performance specs and prices of these?

Any data yet?

I called Professional Products and talked to them for a bit. They don't have anything in writing to distribute yet. They said end of May early June

bink
May 4th, 2006, 02:25 PM
Buy an LS7 intake. Of course you'll need new heads, then.:D