Jdperk-86elco
April 28th, 2006, 08:22 AM
My TCC brake switch input (pin 33 purple if I am not mistaken) is reading 10.4VDC with the wire isolated and ignition on or car running. The scan shows this input "Applied" could this input be bad?
Is my only course of action to get a new PCM? This is causing my cruise to lock out. This is a new swap and the car drives fine and I guess the PCM is compensating for this input being bad. I have yet to get the cruise to work and I installed the Corvette drive-by-wire system.
Any ideas?
Is my only course of action to get a new PCM? This is causing my cruise to lock out. This is a new swap and the car drives fine and I guess the PCM is compensating for this input being bad. I have yet to get the cruise to work and I installed the Corvette drive-by-wire system.
Any ideas?