Wideband Analog Connection Trouble

[fjs6]

Hello everyone,
I'm currently trying to connect my wideband sensor to my V2 flashscan but I keep getting the following error regardless of any changes that I make to the calcpids.
Any help will be greatly appreciated. Thank you in advance.
Error code: ERR_CONFIG/92
C:\Users\Francisco\Documents\EFILive\V7.5\User Configuration\calc_pids.txt(45): Slot F001 not found. .

[joecar]

Using Windows Explorer, can you locate the actual folder pathname that calc_pids.txt is located in...?

Then, in the V7 scantool, go Edit->Properties->Folders and see if the User Configuration folder pathname matches the actual folder pathname you found with WE.

[joecar]

Also:

Your calc_pids.txt is not correct...

this:


*CLC-00-001 10.00 20.0 .1 "{EXT.AD2}*2+10"


should be like this:


*CLC-00-001
AFR 10.00 20.0 .1 "{EXT.AD2}*2+10"


Are you sure there is not an already made calc pid for your wideband...?

[joecar]

Also, the precision would be better at .2 or .3 rather than .1.

[fjs6]

Thanks for the reply joecar.
I checked the pathname both in windows explorer and v7 scantool and they do match. Also I'm using Daytona sensors Wego IV wideband system and I didn't find an existing calcpid for this unit.

[joecar]

Also, there should be at least 2 blank lines at the end of your calc_pids.txt file.

[joecar]

Did you edit CLC-00-001 as shown in post #3 above...?