Script exited with code $0101: No data received

[paint94979]

Truck was giving me all sorts of odd codes upon initial flash. Finally got it to take a DSP5 file then went to make changes via a Cal flash same issue wouldn't take so I went to start it and no start. ECM is working I can hear it power on/off. I am also able to clear codes. What can I try...

[GMC-2002-Dmax]

Its probably a brick, that is the bad code.

Paul or Ross would probably agree.

If you cannot pull a VIN# and ECM SN# and get no response using the get calibration info then its a brick most likely

[paint94979]

Can it brick by doing a Cal flash?

[GMC-2002-Dmax]

Try to read it out, EFI-Live software will alert you if the Cal is bad, try to read it and if the ECM won't boot to read then that is another bad sign.

Usually a CAL Flash won't Brick it, but a Cal flash on an LB7 just alters the base tune and not the DSP5 tunes

[paint94979]

It won't read the ECM.

[GMC-2002-Dmax]

Its most likely bricked, only way to fix it if you cannot pull any codes, or get any info is a Flash Chip replacement.

I lost count how many ecms I have gotten back as cores that were bricked over the last 9 years.

I have not bricked one yet, but plenty of times they brick themselves.

[GMPX]

Would you mind Emailing your tune to support@efilive.com with a link to this thread.

Thanks,
Ross

[paint94979]

Would you mind Emailing your tune to support@efilive.com with a link to this thread.

Thanks,
Ross

I will do it in about 45 minutes

[GMPX]

It is 7pm in NZ....don't rush :music_whistling_1: