View Full Version : Script exited with code $0101: No data received
paint94979
January 14th, 2015, 04:15 PM
Truck was giving me all sorts of odd codes upon initial flash. Finally got it to take a DSP5 file then went to make changes via a Cal flash same issue wouldn't take so I went to start it and no start. ECM is working I can hear it power on/off. I am also able to clear codes. What can I try...
GMC-2002-Dmax
January 14th, 2015, 05:16 PM
Its probably a brick, that is the bad code.
Paul or Ross would probably agree.
If you cannot pull a VIN# and ECM SN# and get no response using the get calibration info then its a brick most likely
paint94979
January 14th, 2015, 05:22 PM
Can it brick by doing a Cal flash?
GMC-2002-Dmax
January 14th, 2015, 05:26 PM
Try to read it out, EFI-Live software will alert you if the Cal is bad, try to read it and if the ECM won't boot to read then that is another bad sign.
Usually a CAL Flash won't Brick it, but a Cal flash on an LB7 just alters the base tune and not the DSP5 tunes
paint94979
January 14th, 2015, 05:28 PM
It won't read the ECM.
GMC-2002-Dmax
January 14th, 2015, 05:30 PM
Its most likely bricked, only way to fix it if you cannot pull any codes, or get any info is a Flash Chip replacement.
I lost count how many ecms I have gotten back as cores that were bricked over the last 9 years.
I have not bricked one yet, but plenty of times they brick themselves.
GMPX
January 14th, 2015, 06:21 PM
Would you mind Emailing your tune to support@efilive.com with a link to this thread.
Thanks,
Ross
paint94979
January 14th, 2015, 06:30 PM
Would you mind Emailing your tune to support@efilive.com with a link to this thread.
Thanks,
Ross
I will do it in about 45 minutes
GMPX
January 14th, 2015, 06:37 PM
It is 7pm in NZ....don't rush :music_whistling_1:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.