PDA

View Full Version : $0340 error



billybob
February 13th, 2015, 09:36 AM
Tried flashing a 09 c&c, receiving a $0340 code. Truck in no start condition. Suspect a dead ecm. Any way to know for sure?

GMPX
February 13th, 2015, 09:47 AM
Probably a protected ECM....see here.
http://download.efilive.com/Tutorials/PDF/Cummins%20BootRSA%20Patch%20User%20Guide.pdf

(http://download.efilive.com/Tutorials/PDF/Cummins%20BootRSA%20Patch%20User%20Guide.pdf)If you can reflash the stock tune back in then that is your problem.

billybob
February 14th, 2015, 01:50 AM
I have bootloader rev 1000601, I will try the patch.

billybob
February 14th, 2015, 02:16 AM
Where do I download the rsa patch for bootloader 601?

2007 5.9
February 14th, 2015, 02:47 AM
The pre-release software contains the patch

billybob
February 14th, 2015, 08:45 AM
Thanks Les!

billybob
February 14th, 2015, 09:42 AM
Can I use the base tune I read out of the truck? In v7.5 it says ok to flash but in v8 it says DO NOT FLASH.

Evil R8
February 15th, 2015, 07:37 PM
Did u check for firmware.. In v8

GMPX
February 15th, 2015, 08:47 PM
As suggested you need to update all your software, from memory the DO NOT FLASH warning was removed from later versions of the software. The tune you read out of the ECM before patching it will be fine to use once the ECM is patched.

billybob
February 16th, 2015, 02:42 AM
Thanks guys, applying the patch solved the problem.