RADustin
March 5th, 2015, 08:16 AM
All,
I am setting up to autoVE my truck with COS5 and 2 bar map.
when I make the table in the efilive scan program following the autoVE tutorial, do I make the table go from 15-105kPa; and another table from 105kPa to 285kPa? or do I do one table from 15-285kPa and just split the table out when I paste back into my tun file?
Not sure if this question has been covered before- I am search inept if it has been...
Thanks!
I am setting up to autoVE my truck with COS5 and 2 bar map.
when I make the table in the efilive scan program following the autoVE tutorial, do I make the table go from 15-105kPa; and another table from 105kPa to 285kPa? or do I do one table from 15-285kPa and just split the table out when I paste back into my tun file?
Not sure if this question has been covered before- I am search inept if it has been...
Thanks!