View Full Version : Innovate LC-2 pids
eacostad
April 15th, 2015, 03:42 PM
Just bought an Innovate LC-2 and im a little confused on how to set it up. Im using a Null Modem to connect it to my V2 and im not sure where im supposed to hook up the brown and yellow spliced wires too. All I can find is LC1 wideband info other than the sticky on top of this page. Also Do i just choose the Innovate (LC1,LM1,LM2) on my flashcan device settings? thanks
joecar
April 15th, 2015, 08:21 PM
Brown and Yellow wires are the analog outputs from the LC-2, leave these unconnected (tape them up to insulate them).
You simply need only the null modem serial comms connection.
Yes, choose Innovate in the V2 wideband config settings.
Also, in the V2 Device Settings, under Logging, checkmark to automatically log the digital/serial pids.
The pids you will log are EXT.WO2xxx.
eacostad
April 15th, 2015, 11:47 PM
thanks for the quick response, just he information I was looking for. Thank you
joecar
April 16th, 2015, 02:12 AM
No worries.
Correction:
Also, in the V2 Device Settings, under Logging, checkmark to automatically log the digital/serial pids.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.