Setting up to pass smog...check this out

[TFZ_Z06]

Do these graphics indicate any problems? I thought I had an EGR system. Do the non supported parameters appear correct?
When I do a code read I get zero codes.

I just removed my EGR plate and flashed it back stock for smog. Anything else I should look for? I'm aware its a code inspection, visual, and 3 sec smoke test.
Log attached also. Towards end of log was WOT.

EDIT: I still have switch wired, but is well hidden. Does it affect the stock setup?

Log file from stock tune no egr plate
(http://home.comcast.net/~booth.p/dmaxclassiclbz.efi)

18344

18345

[joecar]

The "Not Supported" tests have to match the BAR's database for your VIN of what is supported and not supported.

[mpdtune]

Do these graphics indicate any problems? I thought I had an EGR system. Do the non supported parameters appear correct?
When I do a code read I get zero codes.

I just removed my EGR plate and flashed it back stock for smog. Anything else I should look for? I'm aware its a code inspection, visual, and 3 sec smoke test.
Log attached also. Towards end of log was WOT.

EDIT: I still have switch wired, but is well hidden. Does it affect the stock setup?

Log file from stock tune no egr plate
(http://home.comcast.net/~booth.p/dmaxclassiclbz.efi)

18344

18345

Get a generic code reader that supports a monitor check and use that. They're like $150 or so. Most of them have a "State OBD Check" option. You can't disable monitors in EFILive so they should all be there and say they are complete. At a minimum all 98-07 diesels will have a Misfire and Component monitor, so the Scan tool showing those not supported makes me think it's not actually reading them.