PDA

View Full Version : 2012 cummins data logging.


JT_cummins
September 16th, 2015, 11:36 AM
Hey everyone, and thanks in advance. I just deleted and tuned my truck. I want to get a data log done so my tuner can look it over. The only directions I have are for my 2008 that I just sold. So I followed those, started and stopped the recording. Normally after you stop it, it give you the option to save the log. Nothing popped up. I would also like to add that I have searched about 20 pages of posts on the forum trying to find them.

So I guess what I'm asking is, can someone tell me the step by step directions on how to do it for a 2012 cummins 2500 automatic or post a link on my thread as to where I can get them?

Once again thanks again in advance.
ATPCummins
September 17th, 2015, 05:23 AM
You should be prompted to save the data log after stopping it. Are you recording using the red button to start and stop the log? Are you using v7.5?

This may be helpful for you: http://atptrucks.com/blog/data-logging-with-efilive-autocal-and-v2/
JT_cummins
September 17th, 2015, 05:39 AM
Yes, red button to start and stop. I did this several times on my 08. But for some reason having trouble with the 2012. When prompted which ecm do I select?
ATPCummins
September 17th, 2015, 05:55 AM
You will need to select the CMD controller for your 2012 cummins.
JT_cummins
September 17th, 2015, 05:57 AM
Now I don't have the laptop in front of me, but my 08 was the 2100 option correct?
ATPCummins
September 17th, 2015, 06:25 AM
Correct, your 08 was the CMC CM2100.
JT_cummins
September 17th, 2015, 08:34 AM
Awesome, thanks for the help I'll give it a try tomorrow and get back to you. Thanks again for your time!
ATPCummins
September 17th, 2015, 08:48 AM
No problem at all.
JT_cummins
September 17th, 2015, 09:11 AM
One other question. Is there a way to check and make sure the csp5 switch is working?
ATPCummins
September 17th, 2015, 09:33 AM
Yes. There are two basic ways. The first is by watching the LED on the back of the switch. It will flash the tune number selected after turning the knob. What you are actually seeing is the feedback from the ECM showing that the tune has been changed. The second is to watch the CSPTUN_F PID when data logging. It will display the tune number.
JT_cummins
September 17th, 2015, 09:34 AM
Thanks again!
JT_cummins
September 22nd, 2015, 03:29 AM
So my tuner has family in town and I'm not going to bug him. I know every tuner is different but any idea what I should pick for PID'S to log for him?
ATPCummins
September 22nd, 2015, 04:01 AM
The EDA pid group I posted here should have everything that is needed:

http://atptrucks.com/atp-pids

Just click on "CSP" under "10-12 6.7" to download it. It is also already in your efi software.
JT_cummins
September 22nd, 2015, 04:03 AM
Awesome thanks again!