gotabav
September 16th, 2015, 04:51 PM
I'm having an issue logging wideband data. My previous computer and wideband both died and I've replaced them but am having no luck. I'll quit whining now....
Here is the set up
AEM 30-4110 gauge controller hooked to serial output directly to V2. I can read the WB on the LCD read out without any issues and it is spot on with the gauge. Attached is a short scan that I did about and hour ago just to have something to post.
I imagine that I don't have the correct PIDs selected, but don't know for sure.
Any help from the experts would be greatly appreciated.
Just in case it matters, the vehicle is a 2002 Blazer with an L33 swap, 243 heads, LS6 cam and intake, stock Blazer 0411 PCM
Thanks in advance.
Here is the set up
AEM 30-4110 gauge controller hooked to serial output directly to V2. I can read the WB on the LCD read out without any issues and it is spot on with the gauge. Attached is a short scan that I did about and hour ago just to have something to post.
I imagine that I don't have the correct PIDs selected, but don't know for sure.
Any help from the experts would be greatly appreciated.
Just in case it matters, the vehicle is a 2002 Blazer with an L33 swap, 243 heads, LS6 cam and intake, stock Blazer 0411 PCM
Thanks in advance.