I have no clue as to what I am doing.

[[email protected]]

I have just bought efi Live and its connected to the car. Its a ws6 6 speed. Engine is bone stock. I have installed a Dana s60 rear with 4:11 gears. When I correct the parameter for the final drive gear my Speedo doesn't change. I am doing a full scan and full reflash. I would like to change and get into more but my reflash isn't changing anything. I am following the directions it gives me for saving the tune file first. I am following the countdown and it comes up and says that reflash was successful. I am lost.

[joecar]

Post your tune file here.

[[email protected]]

18937

so i am trying to change my rear end gear ratio for my speedo to 4:11 and my Speedo is still off. i also wanted to turn off the skip shift and air injection system

[joecar]

I'll look at your file later tonite when I get home.

[[email protected]]

I'll look at your file later tonite when I get home.

I have not received any help and still need assistance

[limited cv8r]

Have you tried using the speedo calculator in the speedometer/parameters section to adjust your tune? You will maybe have to put "(H0103) Differential Ratio" back to original value before using the calculator.

[joecar]

Sorry for the delay...

So you have 275/40R17 tire...?

[joecar]

H0101 should be 55044, and H0104 should be 3238...

But do what cv8r said above, set the Hxxxx parameters back to stock and click on the Speedo Calculator tool

( you will need to run the V7 tunetool as Administrator )

[[email protected]]

Did all that and it changed the pid but not on my Speedo. So I am sure my entire year of messing with this program has been a waste because I have not registered the software and hardware. How do I get a new registration number? Also side note my pcm selected in v8 shows a 98-00 ls1a but everything else is saying ls1b

[joecar]

Did your V2 come with a blue card in the box...? If not then send an email to [email protected], mention your V2 serial number, and request a registration key.

In V8, can't you rightclick on it and set it correctly (to LS1B)...?