Hard Start, Thinking Cam Sensor, Logs Attached

[BigCE]

My new swap is in running/driving, however I am having a hard start issue. Also it sometimes backfires if you let off during cranking, I have learned if you just stick with it, it will always start and not backfire. Only backfires if you abort the start mid cranking. About 80% of the time when I go to turn it over it has to crank for 5-10 seconds before it will start. Then every once in a while it will flash right up just like a brand new truck, or a 2007 motor should lol.

Has a new Cam Sensors as of today, fixed nothing. :doh:

It is throwing a code for the camshaft. Doing some Google searches I can find other people with the exact same symptoms and code but no real advise.

I logged Cam Signal Input High to Low & Cam Signal Input Low to High, they are both showing zero while cranking and running. Should they be showing something?:confused:

Any help would be greatly appreciated.

Thanks

[joecar]

CAMHL and CAMLH should be counting (and should have a difference of 1 between them).

[BigCE]

Thanks, I was able to log a friends vehicle and seen theirs showed 50-70 counts at idle. I am going to trace the wires today and see if there is a wiring problem or i guess a bad PCM problem. It is a brand new harness from PSI.

[BigCE]

Found the culprit. Brand new harness, oh well things happen.

http://i114.photobucket.com/albums/n258/BigCE_photos/IMG_20160312_120735_zpsqhqmsmaa.jpg (http://s114.photobucket.com/user/BigCE_photos/media/IMG_20160312_120735_zpsqhqmsmaa.jpg.html)