PDA

View Full Version : Modifying misfire detection tables ?



kp
March 4th, 2005, 02:19 PM
pretty much standard thing to do with a large cam is change the idle/low speed misfire detection to 32767 in all cells. been trying for a while to do that easily :) 9998 seems to be the biggest value you can put in in the 'adjust' box and hit #

I would think the easy way would be to hit select all, put 32767 in the 'adjust' box and hit #, am I doing something wrong here?

johnsZ06
March 7th, 2005, 09:19 AM
Since mine only sets the code when I first crank it up, I changed the "Temp" parameters to -> 100*F and no more problems!

GMPX
March 7th, 2005, 10:17 AM
9998 seems to be the biggest value you can put in in the 'adjust' box and hit #

Mmm, right you are, it has been added to the fixup list.

Thanks,
Ross

kp
March 7th, 2005, 11:28 AM
I really dont think there is another table that uses that big of value, my workaroound was just to type 100 in there and keep hitting % until all the cells were maxed out.

GMPX
March 7th, 2005, 12:20 PM
The other option is to manually enter in the value of 32767 into a cell, then ctrl-c to copy the value, click on other individual cells and ctrl-v to paste that value.....might be a bit tedious, but you could populate a table in under a minute that way.

Cheers,
Ross

ForcedC5
May 13th, 2005, 04:27 AM
Just want to confirm.. is this table C5622?

Dirk Diggler
May 13th, 2005, 04:56 AM
If you select all the cells and change one and hit enter it will change all the selected cells

VortechC5
May 13th, 2005, 01:09 PM
Mine does the same thing. Thanks for the tip. I just went in and changed the Min Temp, Startup Min Temp, and Startup Enable Temp to higher values.


Since mine only sets the code when I first crank it up, I changed the "Temp" parameters to -> 100*F and no more problems!