B0101 VE table display units

[Illegal Vette]

I need to set the B0101 table display units from kPa to % and can't seem to find the setting. My log is displayed in g*K/kPa and my B0101 table is displayed in kPa, can anyone point me to the setting for this?

[Jetmech442]

Edit. Properties.

However, the top row in b0101 will say kpa, but the units of the data inside the map are displayed right above the description, to the left of minimum and maximum. There is no setting to display b0101 units in kpa. Just sayin. 😀

[joecar]

Use g*K/kPa everywhere.

in tunetool: Edit->Properties->VE Units: set this to g*K/kPa (same as your log).

Post screenshots (shift-prtscr) of what you see.

edit: JetMech is correct, VE does not have units kPa... those are the units of the horizontal axis (the MAP axis).

[Illegal Vette]

Use g*K/kPa everywhere.

in tunetool: Edit->Properties->VE Units: set this to g*K/kPa (same as your log).

Post screenshots (shift-prtscr) of what you see.

edit: JetMech is correct, VE does not have units kPa... those are the units of the horizontal axis (the MAP axis).

Here's a screencap after changing the units, thanks for that I couldn't go on without it.
19473