View Full Version : ACT PID not communicating
billy badass
April 29th, 2016, 07:07 AM
ever since i flashed my 2001 camaro pcm to a 2bar operating system i cant seem to get the air charge pid to work. Any suggestions?
joecar
April 29th, 2016, 08:02 AM
Which pid...?
Which COS...?
From which GM OS...?
Can you post some screenshots.
billy badass
May 1st, 2016, 03:51 AM
I can't seem to upload any screen shots. Can you just email me?
joecar
May 1st, 2016, 08:06 AM
what's your email address...?
joecar
May 3rd, 2016, 03:13 AM
Ok, email sent.
billy badass
May 4th, 2016, 12:47 AM
Any luck Mr. Car?
joecar
May 4th, 2016, 02:53 AM
From your log file "iat.log" it shows the pid SAE.IAT stuck at -38*F...
this indicates that the IAT sensor wiring is broken.
billy badass
May 4th, 2016, 03:23 AM
I believe that's been checked numerous times. I'll go there myself later and ohm the wires from pigtail right to the pcm connector. I'll get back to you. Thanks again.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.