Engine load to mandate when PE is needed or not

[voda1]

On competitors website forum it was suggested to tune the PE by engine load.

Settings:
B3613 MAP enable to 85 kPa
B3616 Throttle to 10%
? ramp in to 1-1.25 (Did not see any ramp-in parameter for LS1A)
B3618 EQ Ratio to 1.15

Any comments or thoughts on how that might work out?

[joecar]

Hi voda1.

B3613 MAP enable to 85 kPa: this is ok.
B3616 Throttle to 10%: this may make PE enable too easily (I would use 35%).
? ramp in to 1-1.25 (Did not see any ramp-in parameter for LS1A): B3643, this is ok.
B3618 EQ Ratio to 1.15: I would go a little richer to be safe, I would use 1.17.

also: B3608, B3609: set these to zero.