CR500
June 1st, 2016, 02:03 AM
I'm trying to diagnose my 2008 Silverado that just threw:
P0606 ECM/PCM Processor Internal Fault EPA Pending ($00) "Integration/Manufacturer expansion"
P069E Fuel Pump Control Module (FPCM) Requested MIL Illumination EPA Pending ($11) "Engine Control Module (ECM)"
I'd like to be able to command the fuel pump on / off but the DVT only shows a Secondary Fuel Pump (under output control). Nothing pump related under the Fuel System tab. I just noticed the duty cycle control but I'm looking for an on / off.
Any ideas??
Thanks
Rob
P0606 ECM/PCM Processor Internal Fault EPA Pending ($00) "Integration/Manufacturer expansion"
P069E Fuel Pump Control Module (FPCM) Requested MIL Illumination EPA Pending ($11) "Engine Control Module (ECM)"
I'd like to be able to command the fuel pump on / off but the DVT only shows a Secondary Fuel Pump (under output control). Nothing pump related under the Fuel System tab. I just noticed the duty cycle control but I'm looking for an on / off.
Any ideas??
Thanks
Rob