Wide Band viewing on V2

[Harrismarine]

Hi Guys, Can i use my V2 as a gauge to view the wide band when powered up but not connected to a ECU (wide band is connected via serial) basically use it as a gauge?

Cheers Mike

[joecar]

The serial comm interface works with just a USB connection, no OBDII connection required.

The orange analog inputs require 12V via the OBDII connector to function.

[Harrismarine]

Thanks, so if i have it powered with USB and go to Display W02 it should show up? (wide band connected and powered up as usual)

[joecar]

Thanks, so if i have it powered with USB and go to Display W02 it should show up? (wide band connected and powered up as usual)Yes, correct.

[Harrismarine]

That's what i thought..all i get is "WO2 not found" I am betting i haven't got something right. any suggestions?

[joecar]

Did you do this:



- start V8 Scan & Tune (S&T),
- goto F6: Devices,
- goto Logging page,
- checkmark Automatically select ALL digital (serial) PIDs <-- do this for serial wideband
- checkmark Automatically select ALL analog PIDs <-- do this for analog wideband
- set Logging Speed to Fast (10-40 frames/second),
- goto Serial I/O,
- set Com Port to Wideband,
- set Wideband Type to your wideband,
- save to file Settings.dat,
- click Program,
- click Close,
- exit V8 S&T.

More Info: kb_article.php?ref=8371-TIPK-2770 (https://support.efilive.com/kb_article.php?ref=8371-TIPK-2770)

. . .



Also, I take it your WB is powered up.

[Harrismarine]

Yes wide band powered up. I went through it again as you have listed ( I had it correct) and it still shows not found