BBL 2010 Camaro

[camaro10]

Been trying to figure out how to configure it using v8 scan and tune. I think I have the e38 pids loaded on now. Only problem is my wb02 and other custom calc pids I use in v7.5 don't show up and I can't find them under anything for the v.8 scan and tune. Do I need to somehow re-create these pids for v.8 aswell?

[joecar]

Which wideband do you have...?

Post a V7 log file.

[camaro10]

Ballanger Motorsports afr 500. The new remake of the NGK afx. I'll post a log at some time today. Do you want the calc pids I have to for v7?

[camaro10]

Sorry car got put into storage. Here is a log of another Camaro (2013 LS3) Im working on, I would like to use bbl, just got a 16gb sd card, I have dtc definitions loaded. I only really use the v7 scanning. I have a custom calc pids made for the wideband (BALLANGER MOTORSPORTS AFR500). I cannot figure out why the wideband ben will not work. That SAE.LAMBDA pid does work in this car just fine. Also I can view lambda via the wideband in the scan tool, But the ben factor does not work (actual/commanded). Heres what Im working with

[joecar]

Add two blank lines at the end of your calc_pids.txt.

from looking at your calc_pids.txt, you have to log SAE.LAMBDA and EXT.AD1 and EXT.AD2.

[joecar]

You have some interesting idle oscillations going on...

[camaro10]

Indeed I do. But I have it better now. Trying to play with proportional and integral tables. Owner doesnt want to drill a hole and neither do i. Proportional has to be tamed alot and integral has to be linear. What about black box logging to eliminate my laptop for longer logs and get better averages.

[joecar]

In the V2 section of the forum there is a thread o how to setup V2 from scratch (I'll post a url to it when I get to a PC).

~Moderator~

[camaro10]

I guess the question I have is I need to use these custom calc pids. In the scan and tune I could not figure out a way to use them being it's under the v7

[joecar]

Calc pids are not actively logged, they are after-computed when viewing the log in V7/V8 scantools... so they don't show up on the V2 LCD during logging.

[camaro10]

Calc pids are not actively logged, they are after-computed when viewing the log in V7/V8 scantools... so they don't show up on the V2 LCD during logging.

Ok so as far as selecting pids, it's not necessary to select the calculated ones. Such as stft ben or wideband Ben? Because adding the e38 pids under scan and tune doesn't include them. If I don't select them how can I view them later in the scan tool?

[joecar]

Yes, after you captured a log, and you open it in the scantool, you can add the calc pids, and if you Save the log file, the calc pids (and their calculated data) will now be saved in the log file.