PDA

View Full Version : Logging issue



PHIL@ARMORINC
November 4th, 2016, 01:45 AM
My v2 up and decided it doesnt wanna data log some of the pid's, i cant data log a cmd, or cmd at all or the eda's on a cmb but can log balance rates, im runnind v82.2.303 and my v2 is up to date. Any thoughts?? Thanks

Move'n Up
November 4th, 2016, 02:01 AM
I assume these are PID's that you were previously able to log? Have you confirmed your BBX setup to confirm that the PID's are loaded in the V2 BBX config file?

PHIL@ARMORINC
November 4th, 2016, 02:10 AM
Yup, the set up properly and could always log them before

Move'n Up
November 4th, 2016, 02:44 AM
Is this the same vehicle(s) as before? Does the truck have a CSP5 tune loaded? Unless a CSP5 upgraded OS is loaded then you will be limited to what you can data log.

PHIL@ARMORINC
November 4th, 2016, 02:49 AM
Yup same vehicles as always.


Sent from my iPhone using Tapatalk

Move'n Up
November 4th, 2016, 02:54 AM
Yea, that is odd.
Maybe something happened to the file on the V2. I'd try to rebuild and then reload your BBX setup config to your V2 or just reload your BBX setup that you currently have on your PC.

PHIL@ARMORINC
November 4th, 2016, 02:58 AM
very odd, and did that a couple times

Move'n Up
November 4th, 2016, 03:02 AM
I'm all out of troubleshooting and possible solutions then, sorry.
:wtf1:

Hopefully someone else will chime in here.

Blacky
November 6th, 2016, 07:56 AM
My v2 up and decided it doesnt wanna data log some of the pid's, i cant data log a cmd, or cmd at all or the eda's on a cmb but can log balance rates, im runnind v82.2.303 and my v2 is up to date. Any thoughts?? Thanks

When you say "can't log" what error do you see? (if any error at all).

Regards
Paul

PHIL@ARMORINC
November 6th, 2016, 08:34 AM
No error code. Just reads 0's. Except for rpm's


Sent from my iPhone using Tapatalk