Logging issue

[PHIL@ARMORINC]

My v2 up and decided it doesnt wanna data log some of the pid's, i cant data log a cmd, or cmd at all or the eda's on a cmb but can log balance rates, im runnind v82.2.303 and my v2 is up to date. Any thoughts?? Thanks

[Move'n Up]

I assume these are PID's that you were previously able to log? Have you confirmed your BBX setup to confirm that the PID's are loaded in the V2 BBX config file?

[PHIL@ARMORINC]

Yup, the set up properly and could always log them before

[Move'n Up]

Is this the same vehicle(s) as before? Does the truck have a CSP5 tune loaded? Unless a CSP5 upgraded OS is loaded then you will be limited to what you can data log.

[PHIL@ARMORINC]

Yup same vehicles as always.


Sent from my iPhone using Tapatalk

[Move'n Up]

Yea, that is odd.
Maybe something happened to the file on the V2. I'd try to rebuild and then reload your BBX setup config to your V2 or just reload your BBX setup that you currently have on your PC.

[PHIL@ARMORINC]

very odd, and did that a couple times

[Move'n Up]

I'm all out of troubleshooting and possible solutions then, sorry.
:wtf1:

Hopefully someone else will chime in here.

[Blacky]

My v2 up and decided it doesnt wanna data log some of the pid's, i cant data log a cmd, or cmd at all or the eda's on a cmb but can log balance rates, im runnind v82.2.303 and my v2 is up to date. Any thoughts?? Thanks

When you say "can't log" what error do you see? (if any error at all).

Regards
Paul

[PHIL@ARMORINC]

No error code. Just reads 0's. Except for rpm's


Sent from my iPhone using Tapatalk