PCM driven shift light on an auto

[Yortt]

I am using 01290005 operating system and trying to use the air pump output pin red plug pin 36 to drive a shift light at a programmed RPM.
Activated air pump in the platform and adjusted the setting in the Air pump parameters did not work.

While I am running 01290005 operating system which was converted from an Australian operating system is it possible the Australian operating system/tune does not have the relevant information to drive the air pump output!
Can anyone offer any suggestions?

Thanks

[joecar]

Look at G1206/G1207.

[Yortt]

Look at G1206/G1207.

Thanks for the reply I have already set G1206/G1207
Also
B0201
B0202
B0203
B0204
B0205
B0206
B0207
have been addressed.

[turbo_bu]

Do you have to turn on the DTC's to get it to function? C6001 ---> P0410, P0412, P0418? Set them to something like Non Emissions

[joecar]

Do you have to turn on the DTC's to get it to function? C6001 ---> P0410, P0412, P0418? Set them to something like Non EmissionsI'm not sure...

( I know disabling the DTC's prevents the Secondary AIR tests from running )


it might be best to try it and see.

[Yortt]

Do you have to turn on the DTC's to get it to function? C6001 ---> P0410, P0412, P0418? Set them to something like Non Emissions

Interesting!.....I will try it and report back thanks.

[turbo_bu]

I'm not sure...

( I know disabling the DTC's prevents the Secondary AIR tests from running )


it might be best to try it and see.

I guess I meant to say just turn on the sensor, and maybe not the actual Secondary AIR test DTC. Either way, I think that you have to tell the PCM that something is there before it will turn it on.

[joecar]

I guess I meant to say just turn on the sensor, and maybe not the actual Secondary AIR test DTC. Either way, I think that you have to tell the PCM that something is there before it will turn it on.Yes, I agree, PCM has to be told to look for it.

[sweettl69]

Im also interested in this im using a auto trans os but a th400 tried shift light output with a led and it blinks untill set rpm then goes solid i would love to a different output to make this work

[Yortt]

Do you have to turn on the DTC's to get it to function? C6001 ---> P0410, P0412, P0418? Set them to something like Non Emissions
Tried all the settings this did not work either!

[Yortt]

20443
Maybe pin 4 instead of 36?

[Tre-Cool]

I've used the shift light function fine on my drag car.. but it did seem to be a bit hit & miss for working.

I'm going to give it another shot soon, but i'll be using it to trigger a relay that will run a shiftnoid on my turbo 400.

[Yortt]

I've used the shift light function fine on my drag car.. but it did seem to be a bit hit & miss for working.

I'm going to give it another shot soon, but i'll be using it to trigger a relay that will run a shiftnoid on my turbo 400.

Was that using the manual transmission shift light settings in the tune (given the turbo 400) or was it being driven by some other means?

[Tre-Cool]

using a manual calibration tune.

but looking at the tune it's not supposed to be used for auto's.

Looks like my setup is completely different to what your trying to achieve.