LS1B with 3bar custom os scan tool map pid only reads to 255kpa need to see up to 285

[sweettl69]

LS1B with 3bar custom os scan tool sae.map pid only reads to 255kpa need read up to 285kpa the same as the boost ve table :unsure: is there a way to change the sae.map to read 285kpa or o i need a new map so i can log boost past 255kpa need help please

[GMPX]

Don't use SAE.MAP, it will only go to 255kPa (not much we can do about that).
Now I don't recall the exact PID to use for the LS1B but look for 'GM.MAPBOOST_DMA', 'GM.MAP2' or 'GM.MAP3' instead if those are valid for LS1B.

[sweettl69]

only one that i see but couldnt check value is map sensor MAPBOOST_DMA the more info tab is blank do you think this is it. i did notice that the pcm went above 255kpa when in my run but in my map for ben hit a wall at 255kpa and im running 28# boost

[Highlander]

do map voltage and just apply the scaling on a calculated PID if none of that works.