PDA

View Full Version : No way to chose NONE in Scan with the Charts



dbaxter_ss
March 6th, 2005, 01:29 AM
When only wanting 2 of the 4 running, and attempting to modify and existing chart, there is no NONE.

Could that be added?

Ira
March 6th, 2005, 05:23 AM
Two possible solutions. Make a new chart and only set up 2 items or set the color of the one you don't want to see to black. New charts come with nothing set so you can leave them blank.

Ira

dbaxter_ss
March 6th, 2005, 07:19 AM
Yah figured that one out, but kind of a pain if you want to quickly unselect something so you can unclutter a chart.

Ugly way I figured out was to select a calc pid, add it to the chart, then remove the calc pid, the chart then shows the pid striked out and effectively cleans it up.

Most likely now that I think about it, making a NONE pid is the way to fix that.

dbaxter_ss
March 6th, 2005, 07:32 AM
DID IT!!

Add to: 915 or whatever number above what you have

Calculated

*CLC-00-915
% 0.00 0.0 .0 "0"


Add To : Just chose any section just to get it in and f5ff to put it at the very end :D
# Calculated PIDs

CALC.BLANK F5FF CLC-00-915 % Fuel "Empty PID"



Save your sae_generic.txt and reload EFILive :D

Load your LOG, add this calc'ed PID in and then change the charts as needed now having a BLANK one if you just wanted to clean or quickly not have something in a chart on the fly without making a whole new one.

Blacky
March 6th, 2005, 12:22 PM
Or just right click on the chart series' caption and select "Remove <xxx>" where <xxx> is the chart series' caption. :)

Regards
Paul

dbaxter_ss
March 6th, 2005, 12:24 PM
:oops:
DOH!!!

Guess that will work too ;)

Ira
March 6th, 2005, 04:33 PM
So obvious when he points it out, so hidden when he doesn't!

Ira