View Full Version : Error code $050C
Tylerlear
February 26th, 2017, 08:04 AM
Hey guys, trying to read a lml duramax ecm I believe it's E86. Everytime I go to tune, then read error $050C comes up. Firmware and all software are up to date. I've already checked A50 and E86 on the bbx and program configuration (slower). Any help is appreciated
modpcm
February 26th, 2017, 08:57 AM
You can't read LML, you can only flash the controller
Tylerlear
February 26th, 2017, 09:00 AM
You can't read LML, you can only flash the controller
Ok so skip straight to program full?
GMPX
February 26th, 2017, 09:02 AM
Or program cal, there is no real need to have to program full on an LML unless you are swapping OS's for some reason.
Tylerlear
February 26th, 2017, 09:03 AM
Ok thanks. So if I have already hit program full have I done went to far? Haven't messed with efi in 10 years and a lots changed
GMPX
February 26th, 2017, 05:08 PM
No, as long as you let the flash complete that is fine.
John McCain
December 8th, 2017, 05:39 PM
I would like clarification please, with $050C error code, there is no need to use the READ 1 option? Go to program FULL 1?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.