PDA

View Full Version : Autocal memory can't take two E92 files!



wesam
April 16th, 2017, 11:53 PM
I just purchased a Autocal for a customer to have two tunes for his truck but find out that Autocal memory is 6.2MB while the E92 file size is 3.14 so we can't put two files in it
Is there any way we could use two files with Autocal with out using laptop ?

Thanks in advance

GMPX
April 25th, 2017, 09:00 AM
Use a .coz file instead, this only saves the calibrations area instead and is much smaller. Of course you cannot full flash the ECM with one of the .coz files but if it is for the same car then that probably does not matter as you will be doing calibration flashes most likely.

wesam
April 25th, 2017, 02:41 PM
Use a .coz file instead, this only saves the calibrations area instead and is much smaller. Of course you cannot full flash the ECM with one of the .coz files but if it is for the same car then that probably does not matter as you will be doing calibration flashes most likely.

Thanks a lot for your help
no need for full flash just cal flash
but how could i save it in .coz ? i tired to save the file as but there is just .ctz format ?!

GMPX
April 25th, 2017, 03:14 PM
It can be done in V8.
With your file open in V8 go to the 'Save' button and you will see the 'Save Calibration Only' option.