View Full Version : serial lc-1 logging
B18B1LS1
July 8th, 2017, 09:32 AM
How close should my logged lambda be to what my Dyno Tune gauge is displaying? I seem to be logging .2 AFR richer than what my gauge reads. Not a huge deal, but it would be nice if they were closer.
Also, is there some way to get my gauge to display in lambda, I'm not a fan of AFR anymore.
Thanks!
joecar
July 9th, 2017, 08:29 AM
Where are the sensors located...?
Which gauge do you have...?
B18B1LS1
July 9th, 2017, 10:10 AM
O2 sensor is about 24" off the turbo. The gauge is the round digital Dyno Tune Air/Fuel, like this, https://www.dynotunenitrous.com/store/scripts/prodView.asp?idproduct=388
joecar
July 10th, 2017, 10:37 AM
Do you have the user manual pdf's for the LC-1 and the gauge...?
B18B1LS1
July 10th, 2017, 10:56 AM
I don't believe so. I've had these over 10 years I bet. You think I have the voltage offsets wrong for the gauge maybe?
joecar
July 10th, 2017, 11:13 AM
Does the gauge run from on eof the LC-1's analog output's...?
If so, then you can use the LC-Programmer software (from Innovate) to tweak analog output a little to make the gauge match.
B18B1LS1
July 10th, 2017, 12:44 PM
Yes it's on 1 of the analog outputs. So what I'm logging is the most accurate because its coming straight from the serial connection on the LC-1. And the gauge is just interpreting the values programmed into it. Bring the gauge inline and all is well. Thanks joecar, seems so simple after typing it out!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.