redtacoma31
August 25th, 2017, 01:56 PM
Hello,
I recently installed a 2000 LQ4 into my Chevelle. I have continuity from the sensor to the computer. The wires are in the correct computer connector locations but I am not getting some of my PIDS to work.
ECT reads -40
IAT reads -40
LTFT Bank 1 reads -100 all the time but Bank 2 works fine.
The electric fans seem to kick on when the engine warms ups but the low speed comes on once the engine is started. I set the on temp of 85C.
I ohmed the ECT and it was perfect.
I swapped the O2 and it did not follow.
Can you please help me?
I recently installed a 2000 LQ4 into my Chevelle. I have continuity from the sensor to the computer. The wires are in the correct computer connector locations but I am not getting some of my PIDS to work.
ECT reads -40
IAT reads -40
LTFT Bank 1 reads -100 all the time but Bank 2 works fine.
The electric fans seem to kick on when the engine warms ups but the low speed comes on once the engine is started. I set the on temp of 85C.
I ohmed the ECT and it was perfect.
I swapped the O2 and it did not follow.
Can you please help me?