V8 Scan - Calculated Ben factor

[Tre-Cool]

Have the following setup for the aem analog ad4 port, but the factor never changes from 1. Any idea's?


[AEM]
AD4LAMBDA="AD4 AEM Lambda",lambda,1
BENAEMAD4="AEM BEN",factor,3
AD4AFR="AD4 AEM AFR",AFR,1

[AEM.AD4LAMBDA]
0=|-- AEM.AEMAD4L
1=|return pid("EXT.AD4")*0.1621+0.4990

[AEM.BENAEMAD4]
0=|-- AEM.BEN
1=|return pid("AEM.AD4LAMBDA")/pid("ECM.EQ_RAT")

[AEM.AD4AFR]
0=|-- AEM.AEMAD4AFR
1=|return pid("AD4")*2.3750+7.3125

Log file attached
21483

[Ninety8C5]

I have a semi-colon at the end of each entry.

[AEM.AD4AFR]
0=|-- AEM.AEMAD4AFR
1=|return pid("AD4")*2.3750+7.3125;

[joecar]

...
[AEM.BENAEMAD4]
0=|-- AEM.BEN
1=|return pid("AEM.AD4LAMBDA")/pid("ECM.EQ_RAT")
...
You mean the BEN is always 1...?

Can you attach a log file.

[Tre-Cool]

log file is attached already Joe.

Yes the ben is always 1.

I have another problem where the log always stops at 478kb in size with a error. Not sure if it's the v2 causing it, but it has the same error & log files are always the same size. Doesnt seem to matter what version or usb port i use.

It's been on on-going thing for a long time, as even with the v7 logger i get a small freeze wile logging sometimes before it continues.

[Tre-Cool]

21487

This is the error i get while logging with v8 too.

[Tre-Cool]

fixed the graph issue. it was only showing 1 because the graph precision needed to be changed to 3.

i also un-installed, cleared all the installed software. now the ben is working in the maps section too, Go figure.

will see if that also resolves the connection drop out

[joecar]

Ah, I see it.

Where do you change the precision...?

[Tre-Cool]

chart properties. click on the cell window. then change value precision.

Might be a question for Ross/Paul as to how to set that default amount to match the pid value