PDA

View Full Version : RTACS tuning w/wideband



Tom B.
September 12th, 2017, 05:20 AM
I am going to attempt to calc VET with the RR. How do I connect my wideband to do this?

joecar
September 12th, 2017, 05:49 AM
Which wideband do you have...?

Tom B.
September 12th, 2017, 05:52 AM
Lc-2

Tom B.
September 12th, 2017, 06:19 AM
I wasn't sure if I left the flash/scan w/ widebands in the aldl port, or did I need to do something different.

joecar
September 12th, 2017, 07:49 AM
Are you going to use your LC-2 with analog connection or serial comm connection to FSV2...?

analog:
connect LC-2 channel 1 signal (yellow) to FSV2 AD1+
connect LC-2 system ground (black) to FSV2 AD1-
then log EXT.AD1;
you will need a BEN pid (CALC.WO2BEN defined for analog LC-2, see Calc.VET thread).

serial:
connect LC-2 serial comm output to null-modem adapter to FSV2 serial comm input
then log EXT.WO2LAM1, EXT.WO2EQR1, EXT.WO2AFR1, EXT.WO2ST1;
you need a BEN pid (CALC.WO2BEN defined for serial comm, see Calc.VET thread).


note: null modem adapter crosses RX and Tx, it must say null modem on it (otherwise it is straight thru).

Tom B.
September 12th, 2017, 08:31 AM
I have been using the serial configuration. I wasn't quite sure if I needed to anything different as far as physically connecting the cables from the ALDL, the Flashscan,and my laptop with the RR installed. I was thinking that the flashscan needed to be connected to a second USB port. I called Moates and spoke with one of the guy's that never worked w/a RR. He was very courteous, but couldn't give me a for sure answer.

joecar
September 12th, 2017, 11:38 AM
You connect to the RR as follows:

V7 tunetool -> USB -> RR

V7 scantool -> FSV2 -> ALDL/OBD2 -> RR


so while V7 tunetool talks to RR, the V7 scantool logs the various pids, and the BEN pid feed back into the V7 tunetool to correct the current table.


( when I say V7 tunetool/scantool, I actually mean V7.5, or the most current )

Tom B.
September 12th, 2017, 12:16 PM
Thank you. I wasn't sure if the FSV2 would communicate through the ALDL to the RR.

Tom B.
September 15th, 2017, 08:38 AM
1st time out and RTACS works as advertised.

joecar
September 15th, 2017, 12:12 PM
correction to my prior post:


...

V7 tunetool -> USB -> RR

V7 scantool <- FSV2 <- ALDL/OBD2 <- RR

...