New to this and need help!!!

[RodHewitt]

This is my first LS motor swap in my 68 Chevy C 10. What I

[joecar]

Please go ahead and complete your post.

[RodHewitt]

This is my first LS motor swap in my 68 Chevy C 10. What I

It runs bad when cold, and OK when it

[joecar]

What was the donor vehicle...? You got the engine from this...? You got the ECM from this...?

Did you modify the engine...?

Did you edit the ECM...?

[RodHewitt]

For some reason it’s not showing my whole replies.

[RodHewitt]

LQ9 bottom end, LS3 tip end, Headers and an aftermarket cam. 224/230 with a 595/600 lift with a 114+ for lobe separation.

[RodHewitt]

Runs bad when cold, very rich. Was stalling all the time. I put a Dakota digital 8000 pulse generator speed sensor on it, and it quit stalling every time I came to a stop! That little since remade the drivability a lot better. It

[RodHewitt]

2003 Escalade PCM/drive by wire tech module

[joecar]

What Windows OS are you guys running...?
What PC/laptop device are you running on...?

[joecar]

LQ9 bottom end, LS3 tip end, Headers and an aftermarket cam. 224/230 with a 595/600 lift with a 114+ for lobe separation.Which intake manifold are you running...(probably the LS3 car manifold vs the LQ4 truck manifold)...?