PDA

View Full Version : E92 pcm and class 2 gauges is this possible?



04colyZQ8
February 5th, 2018, 01:43 PM
Can any of the E92 or SIDI computers talk class 2 data? I'd like to run one of these in a older Colorado canyon, with class 2 gauges.

GMPX
February 5th, 2018, 01:48 PM
No, the E67 was the last ECM GM put class 2 in to, it's long gone.

04colyZQ8
February 6th, 2018, 03:31 AM
No, the E67 was the last ECM GM put class 2 in to, it's long gone.

So the hardware isn't in the controller?

What would happen if I connected the can from the e92 to a e67, would the class 2 on the e67, then output the speedo, rpm and temp via class 2 from the e67? I doubt it?

DURAtotheMAX
February 6th, 2018, 06:17 AM
So the hardware isn't in the controller?

No.


What would happen if I connected the can from the e92 to a e67, would the class 2 on the e67, then output the speedo, rpm and temp via class 2 from the e67?

No.


You would have to design and build your own Class 2 <--> CAN gateway/translator module.