PDA

View Full Version : Unable to Edit Trans Diag, Fuel Sys, System, Speedo


Supercharged111
October 13th, 2018, 05:50 AM
Like the title says on 1 particular vehicle suddenly none of the tunes will allow me to edit the trans diagnostics, fuel system, system, or speedo. All other vehicles will expand these menus and allow me to make changes. I have made changes to these tables in the past, so I'm baffled as to why I can't now. Any ideas? My software is old as hell but I don't see that being a factor here. I've attached an image for reference.

22458
joecar
October 14th, 2018, 09:15 AM
Post your tune file (or email it to me)(pm me for email address).
Supercharged111
October 14th, 2018, 04:01 PM
Derr. Here's what it's running now, don't judge.

22461
GMPX
October 14th, 2018, 05:06 PM
Not sure what the issue could be but I see all segments when I open the file - latest public release.
Supercharged111
October 14th, 2018, 05:18 PM
GMPX is the dropdown arrow there for the segments in question?
GMPX
October 14th, 2018, 06:38 PM
Sure is.

22464
joecar
October 16th, 2018, 08:09 AM
I opened your tune file, all segments show up and expand ok for me.
GMPX
October 16th, 2018, 09:29 AM
Do you maybe have a .cax file loaded that might be causing problems somehow?
Supercharged111
October 17th, 2018, 04:20 PM
Do you maybe have a .cax file loaded that might be causing problems somehow?

Hmm, I'll have to dig into that. No recent changes to my cax situation. You know what I did do though was dump a calz in from a newer software version. It gave me access to transient fueling, but now I wonder if it isn't screwing with the other segments in question.
Supercharged111
October 18th, 2018, 03:50 PM
Switched back to original .calz file, no dice. Also created an archive folder in my CAX folder and dumped everything into that and same deal. Is there a repository of old software versions somewhere? My laptop is running V7.5.5 but my desktop ran something a touch newer that was compatible. Unfortunately that HDD took a dump and I don't even know what version it was.
Supercharged111
January 27th, 2019, 05:51 AM
I swapped in all the .calz files for the entire LS1B folder from a newer 7.5 and voila, all my system stuff is there again. Just had to dig up an old HDD, run it as a slave, and wade through all the stuff I never carried over to the new one. As you may have guessed I put that off for a good while.
joecar
January 27th, 2019, 08:59 AM
Good job :cheers:
Kacey
May 22nd, 2019, 08:46 PM
Not sure what the issue could be but I see all segments when I open the file - latest public release.