PDA

View Full Version : p0191


TNT
November 6th, 2018, 03:57 AM
Have a customers vehicle that is setting a P0191. Rail pressure sensor has been replaced, ran injector return rates and all checked out. Rail overflow valve also new. Looks like Dodge has updated software 2 times for same code. No way to modify parameters to stop diagnostics from running?
2007 5.9
November 6th, 2018, 04:15 AM
Not unless you disable the code
TNT
November 6th, 2018, 04:20 AM
Do not see option to disable with EFI Live no diagnostics tab.
2007 5.9
November 6th, 2018, 04:21 AM
What year truck?
TNT
November 6th, 2018, 04:23 AM
2012
2007 5.9
November 6th, 2018, 04:25 AM
Then you might look into finding the most current calibration for that vehicle and flashing it in
TNT
November 6th, 2018, 04:28 AM
I've already checked and it is at the latest and greatest. Looks like I'm SOL !!
TNT
November 6th, 2018, 04:31 AM
Inherited vehicle from local dodge dealer they threw up their hands and kicked it to the curb.
2007 5.9
November 6th, 2018, 04:43 AM
Is the truck tuned or stock?
TNT
November 6th, 2018, 05:11 AM
Stock
Torque_beast
November 6th, 2018, 05:22 PM
A guy I know had this issue and replace sensor but the new sensor was bad out of the box so he had to order another and it fixed it. If your sure your sensor is good, injectors are good and relief is good then check your wiring. Does it set code after sitting a while? Only when cold? Can you clear code after engine is running and keep code from coming back? I have read about a few trucks in the 11-12 model year with this issue and it ended up being an injector issue.


Sent from my iPhone using Tapatalk
TNT
November 7th, 2018, 03:31 AM
The architecture for setting this code is that it will only run the diagnostics after an 8 hour cold soak, must be at idle, and at operating temp. Takes 2 consecutive failures to set off CEL. So after clearing the code, it takes two days to reset. Diagnostics compare the rate of change in fueling with respect to the rate of change of pressure to a calibrated fail high threshold or above the calibrated fail low threshold while the monitor was running. Would really like to know what the actual calibrated thresholds are.
Torque_beast
November 7th, 2018, 05:08 AM
Not sure on that. Have the injectors ever been removed?


Sent from my iPhone using Tapatalk
TNT
November 7th, 2018, 07:45 AM
Not sure on that. Have the injectors ever been removed?


Sent from my iPhone using Tapatalk

no all stock