PDA

View Full Version : Turbo Swap



hacklerjason
March 20th, 2019, 05:37 AM
Are there any tables that affect input of the vgt? Our actuator is a 12vdc motor with 3 wire analog feedback and I need access to the feedback signal. We are swapping a gtb2260vk into it in favor of the gtb1652vkl.... Any insight is always appreciated!

Sent from my LG-H932 using Tapatalk

hacklerjason
March 21st, 2019, 10:14 PM
Bump

Sent from my LG-H932 using Tapatalk

hacklerjason
March 22nd, 2019, 10:29 AM
bumping 44 views

GMPX
March 24th, 2019, 10:54 AM
As in the position rescaling?

hacklerjason
March 24th, 2019, 11:10 AM
As in the position rescaling?Yes sir that be it! Looking for either analog voltage or hz, not sure... Drawing shows 3 wire analog pot for the actuator position sensor but I have a feeling based on inspection in the actuator that is not the case

Sent from my LG-H932 using Tapatalk

hacklerjason
April 16th, 2019, 08:23 AM
any steam? I wanted to ask you another side question... I would like to chip in, i would like to see what it is that you guys see. I dont know where to start? I have a stock file i read out with alien KESSv2 and am able to see the hex. Where do i begin the process?

hacklerjason
May 22nd, 2019, 06:08 AM
Found the signal being sent from the VGT to be in SENT protocol and I'm not able to alter that signal. Anything that we are able to do to change the type of input? Any way you could point me in the way of looking on my own?

Sent from my LM-V405 using Tapatalk

hacklerjason
May 28th, 2019, 05:33 PM
Bump

Sent from my LM-V405 using Tapatalk