voda1
August 17th, 2019, 09:15 AM
My B5914 low spark table is using {link: GM.DYNCYLAIR_DMA} but the scaling only goes to 1.00 Where the PID data collected in the log shows max of 4.16???
How can this be fixed?
22983
open loop SD with LS1A
Or asked another way: How can I change {link: GM.DYNCYLAIR_DMA} to {link: GM.DYNCYLAIR} in the tune tool?
Here is the entry from my cal_link.txt file:
;Low octane spark map
B5914.ROW=SAE.RPM
B5914.COL=GM.DYNCYLAIR,GM.DYNCYLAIR_DMA,GM.CYLAIR_ DMA,CALC.CYLAIR
Using GM.DYNCYLAIR in the pid file.
How can this be fixed?
22983
open loop SD with LS1A
Or asked another way: How can I change {link: GM.DYNCYLAIR_DMA} to {link: GM.DYNCYLAIR} in the tune tool?
Here is the entry from my cal_link.txt file:
;Low octane spark map
B5914.ROW=SAE.RPM
B5914.COL=GM.DYNCYLAIR,GM.DYNCYLAIR_DMA,GM.CYLAIR_ DMA,CALC.CYLAIR
Using GM.DYNCYLAIR in the pid file.